Product Details
Jemmco's Premium JemmTrac™ 811 Dimpled Traction Tape offers very good release qualities to prevent building up of adhesives, inks and coatings on rollers or drums.
Featuring an acrylic adhesive, the JemmTrac™ 811 eliminates the common challenge of oozing and sticky residue that's typical with a silicone adhesive. The high adhesion guarantees a safe bonding to rollers or drums.
Features
- Very good release properties
- Silicone dimples on uncoated fabric
- Acrylic adhesive for easy clean-up
Technical Specifications
| Release Properties |
Fair |
| Traction Properties |
Very Good |
| Heat Resistance |
-40°C to 125°C |
| Wear Resistance |
Good |
| Hardness |
N/A |
| Adhesive Type |
Acrylic |
| Surface Finish |
Dimpled |
| Wall Thickness |
0.52 mm |
| Available Widths |
2.0" |
| Available Lengths |
6 meters |
| Liner |
No |
| FDA Compliant |
No |
Installation
Four Simple Steps for In-Plant Tape Installation!
- 1.
To get started, wrap your Jemmco tape one full rotation around the roller at the angle required to achieve your spiral. Make a mark on the second wrap where it meets the beginning of the tape.
- 2.
Lay the tape on a flat cutting surface and cut the tape at an angle from the marked point to the opposite corner of the beginning of the tape roll.
- 3.
If applicable, remove the liner at the start point and begin wrapping the tape at the edge of the roller.
- 4.
Wrap the tape around the roller - at even angles - without leaving any gaps or air underneath the tape.
